Kia Sportage: Charging System / Battery Sensor Repair procedures

Kia Sportage QL (2015-2024) Service Manual / Engine Electrical System / Charging System / Battery Sensor Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) terminal.

2.	Disconnect the battery sensor connector (A).

3.	Remove the battery. (Refer to Engine Electrical System - "Battery")

Remove the battery negative (-) cable after removing the bolt (A).

Battery sensor cable mounting bolt:

26.5 - 35.3 N·m (2.7 - 3.6 kgf·m, 19.5 - 26.0 lb·ft)

Installation

Install in the reverse order of removal.

When battery sensor signal fault occurs, inspect the vehicle parasitic draw in advance after inspecting the sensor because the sensor will behave abnormally when the parasitic draw is more than 100mA. (Refer to vehicle parasitic current inspection)

After reconnecting the battery negative cable, AMS function does not operates until the system is stabilized, about 4 hours.

If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with AMS function, Battery sensor recalibration procedure should be performed after finishing the repair work. (Refer to Battery Sensor Recalibration Procedure)

For the vehicle equipped with a battery sensor, be careful not to damage the battery sensor when the battery is replaced or recharged.

1)	When replacing the battery, it should be same one (type, capacity and brand) that is originally installed on your vehicle. If a battery of a different type is replaced, the battery sensor may recognize the battery to be abnormal.

2)	When installing the ground cable on the negative post of battery, tighten the clamp with specified torque. An excessive tightening torque can damage the PCB internal circuit and the battery terminal .

3)	When recharging the battery, ground the negative terminal of the booster battery to the vehicle body.

Battery Sensor Recalibration Procedure

After reconnecting the battery negative cable, AMS function does not operates until the system is stabilized, about 4 hours. If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with AMS function, Battery sensor recalibration procedure should be performed after finishing the repair work.

1.	Turn the Iginition switch ON and OFF.

2.	Park the vehicle for about 4 hours with the hood and all doors closed.

Battery Sensor Description and operation

Description Vehicles have many control units that use more electricity. These units control their own system based on information from diverse sensors. It is important to have a ...

Cruise Control System

...

Other information:

Kia Sportage QL (2015-2024) Owners Manual: Using the Tire Mobility Kit

- Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast. 1. Thoroughly shake the sealant bottle. 2. Screw connection hose (10) onto the connector ...

Kia Sportage QL (2015-2024) Service Manual: CVVT Oil Control Valve (OCV) Description and operation

Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, whi ...