Kia Sportage: Mirrors / Rolling code programming

Kia Sportage QL (2015-2025) Owners Manual / Features of your vehicle / Mirrors / Rolling code programming

To train a garage door opener (or other rolling code equipped devices) with the rolling code feature, follow these instructions after completing the “Programming” portion of this text. (A second person may make the following training procedures quicker & easier.)

4. Locate the “learn” or “smart” button on the device’s motor head unit. Exact location and color of the button may vary by product brand. If there is difficulty locating the “learn” or “smart” button, reference the device’s owner’s manual or contact HomeLink at 1-800- 355-3515 or on the internet at www.homelink.com.

5. Press and release the “learn” or “smart” button on the device’s motor head unit.You have 30 seconds to complete step number 6.

6. Return to the vehicle and firmly press and release the programmed HomeLink button up to three times. The rolling code equipped device should now recognize the HomeLink signal and activate when the HomeLink button is pressed. The remaining two buttons may now be programmed if this has not previously been done. Refer to the “Programming” portion of this text.

Programming
Your vehicle may require the ignition switch to be turned to the ACC position for programming and/or operation of HomeLink. It is also recommended that a new battery be replaced in the hand-held t ...

Operating HomeLink
To operate, simply press the programmed HomeLink button. Activation will now occur for the trained product (garage door, security system, entry door lock, estate gate, or home or office lighting). ...

Other information:

Kia Sportage QL (2015-2025) Service Manual: UIP (Ultrasonic Intrusion Protection) Sensor Repair procedures


Removal UIP Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp. (Refer to Lighting System - "Overhead Console Lamp") 3. Disconnect the UIP se ...

Kia Sportage QL (2015-2025) Service Manual: Rear Shock Absorber Repair procedures


Removal 1. Remove wheel nuts, wheel and tire (A) from hub. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)    ...

Copyright © www.ksportagegl.com 2015-2025