Kia Sportage: Auto Lighting Control System / Description and operation

Kia Sportage QL (2015-2025) Service Manual / Body Electrical System / Auto Lighting Control System / Description and operation

Description
It's a system that uses illumination sensor to automatically turn ON the tail lamp and head lamp based on the change in surrounding environment's illumination condition. It activates when the vehicle enters/exits tunnel, or when the illumination condition in surrounding environment changes due to rain, snow, or fog. Precautions corresponding to the use of this system are as follows.
1.
Do not add another device on top of this device.
2.
Be sure to switch to manual during poor visibility climate, such as fog, heavy rain, or cloudy weather.
3.
Illumination intensity in an actual vehicle is not always constant, and lamp ON/OFF time may very depending on the climate, season, and surrounding environment.
4.
Use this system only during sunrise and sunset period, and manually control lamp ON/OFF for general conditions.
5.
Error may occur if light block coating that may change interior illumination is applied.
Schematic diagrams
Circuit Diagram ...

Auto Light Sensor Repair procedures
Inspection Check if the auto light control operates like a timing chart shown below. Tail lamp output and head lamp (Low) output is controlled based on the auto light sensor' ...

Other information:

Kia Sportage QL (2015-2025) Service Manual: MDPS ECU Repair procedures


Replacement 1. Disconnect the battery negative cable. 2. Remove the crash pad lower panel. (Refer to Body - "Crash pad lower panel") 3. Disconnect the MDPS ECU connector (A). ...

Kia Sportage QL (2015-2025) Owners Manual: Tire chains


Tire chains, if necessary, should be installed on the front wheels. Be sure that the chains are installed in accordance with the manufacturer's instructions. To minimize tire and chain wear, do not continue to use tire chains when they are no longer needed. When driving on roads covered ...

Copyright © www.ksportagegl.com 2015-2025