Kia Sportage: Seat belt restraint system / Stowing the rear seat belt
- The rear seat belt buckles can be stowed in the pocket between the rear
seatback and cushion when not in use.
- The center seat belt can be stowed with the plate and webbing rolled in
the pocket between the rear seatback and cushion.
- Routing the seat belt webbing through the rear seat belt guides will help
keep the belts from being trapped behind or under the seats.
After inserting the seat belt, tighten the belt webbing by pulling it up.
CAUTION
Take the seatbelt out of the seatbelt guide prior to using it. If you pull
the seat belt when it is stored in the guides, it may damage the guides and/or the
belt webbing.
To fasten your seatbelt:
1. Extract the tongue plate (A) from the hole on the belt assembly cover.
2. Insert the tongue plate (A) into the buckle (A’) until an audible “click"
is hear ...
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat
belts (retractor pretensioner and EFD (Emergency Fastening Device)). The pre-tensioner
seat belts may be a ...
Other information:
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON
position.
- It illuminates for approximately 3 seconds
- It remains on if the parking brake is applied.
When the parking brake is applied.
When the brake fluid level in the reservo ...
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and
is installed on the surge tank. It senses absolute pressure of the surge tank
and transfers the analog signal proportional to the pressure to the ECM. By
using this signal, the ECM calcul ...