Kia Sportage: Folding key / Transmitter precautions
- The transmitter will not work if any of following occur:
- The ignition key is in the ignition switch.
- You exceed the operating distance limit (about 30 feet [10 m]).
- The battery in the transmitter is weak.
- Other vehicles or objects may be blocking the signal.
- The weather is extremely cold.
- The transmitter is close to a radio transmitter such as a radio substation
or an airport which can interfere with normal operation of the transmitter.
- When the transmitter does not work correctly, open and close the door
with the ignition key. If you have a problem with the transmitter, contact an
authorized Kia dealer.
- If the transmitter is in close proximity to your mobile phone, the signal
could be blocked by your mobile phones normal operational signals. This is especially
important when the phone is active such as making and receiving calls, text
messaging, and/or sending/receiving emails. Avoid placing the transmitter and
your mobile phone in the same pants or jacket pocket and always try to maintain
an adequate distance between the two devices.
CAUTION - Transmitter
Keep the transmitter away from water or any liquid as it can become damaged
and not function properly.
✽ NOTICE
If the keyless entry system is inoperative due to exposure to water or liquids,
it will not be covered by your manufacturer’s vehicle warranty.
Used to start the engine.
Used to lock and unlock the doors.
To unfold the key, press the release button then the key will unfold automatically.
To fold the key, fold the key manually whil ...
The transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gentl ...
Other information:
The indicator on the switch will illuminate when the Blind Spot Detection System
(BSD) switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds 20 mph (32 km/h), the system will activate. If you press
the switch again, the switch indicator and system will be turned off ...
Inspection
1.
Switch "OFF" ignition.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the solenoid valve connector (A).
...